{"product_id":"1140624-level-sensor-genuine-volvo-penta","title":"1140624 Level Sensor | Genuine Volvo Penta Part","description":"\u003ch2\u003e\n 🔧 Product Description\n\u003c\/h2\u003e\n\u003cp\u003e\n A genuine Volvo Penta water-level sensor for compatible fuel-filter and water-separator assemblies. The sensor detects accumulated water in the filter bowl and activates the Volvo warning circuit before contamination reaches the injection system. It is commonly used with alarm kit 1140609 and the corresponding warning bulb and socket. The sensor must be installed in the specified filter bowl or drain port and connected to the correct 12V or 24V warning circuit.\n\u003c\/p\u003e\n\u003ch2\u003e\n 🚤 Compatibility\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  \u003cstrong\u003e\n   HP Range:\n  \u003c\/strong\u003e\n  Approximately 100-370 HP\n \u003c\/li\u003e\n \u003cli\u003e\n  \u003cstrong\u003e\n   Year Range:\n  \u003c\/strong\u003e\n  Approximately 1980s - 2000s\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n ⚙️ Key Features\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Genuine Volvo Penta water-in-fuel level sensor\n \u003c\/li\u003e\n \u003cli\u003e\n  Correct Volvo Penta part number 1140624\n \u003c\/li\u003e\n \u003cli\u003e\n  Monitors water accumulation in a fuel separator\n \u003c\/li\u003e\n \u003cli\u003e\n  Interfaces with Volvo Penta alarm kit 1140609\n \u003c\/li\u003e\n \u003cli\u003e\n  Protects injection pumps and injectors from water contamination\n \u003c\/li\u003e\n \u003cli\u003e\n  Engine type: Volvo Penta marine diesel fuel filtration and alarm system\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔌 Function\n\u003c\/h2\u003e\n\u003cp\u003e\n The sensor detects conductive water collected at the bottom of the fuel separator and completes the warning circuit so the operator can drain the filter before fuel-system damage occurs.\n\u003c\/p\u003e\n\u003ch2\u003e\n ⚠️ Common Signs of Failure\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Water-in-fuel warning remains on after the bowl is drained\n \u003c\/li\u003e\n \u003cli\u003e\n  Warning does not activate during a sensor test\n \u003c\/li\u003e\n \u003cli\u003e\n  Sensor terminals are corroded or damaged\n \u003c\/li\u003e\n \u003cli\u003e\n  Fuel or water leaks around the sensor seal\n \u003c\/li\u003e\n \u003cli\u003e\n  False alarms occur because the bowl or sensor is contaminated\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🛠️ Service Notes\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Note the wiring and the sensor's orientation before removal, and isolate the circuit so nothing is live while the sender is out\n \u003c\/li\u003e\n \u003cli\u003e\n  Check the float or probe moves freely through its full travel before fitting, and that nothing inside the tank or reservoir can foul it\n \u003c\/li\u003e\n \u003cli\u003e\n  Seal the thread or flange as the installation specifies, and be sparing with sealant on a sender that earths through its body — an insulated sender reads nothing at all\n \u003c\/li\u003e\n \u003cli\u003e\n  Do not over-tighten; these are thin-walled sensor bodies going into thin-walled tanks and housings\n \u003c\/li\u003e\n \u003cli\u003e\n  Prove the installation end to end afterwards, confirming the gauge or alarm responds correctly at both ends of the range rather than assuming a new part must be good\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔄 Supersession \u0026amp; Cross Reference\n\u003c\/h2\u003e\n\u003ch3\u003e\n OEM \/ Related Numbers\n\u003c\/h3\u003e\n\u003cul\u003e\n \u003cli\u003e\n  1140609 related water-in-fuel alarm kit\n \u003c\/li\u003e\n \u003cli\u003e\n  808175 related warning-lamp socket\n \u003c\/li\u003e\n \u003cli\u003e\n  19923 related 12V 2W warning bulb\n \u003c\/li\u003e\n \u003cli\u003e\n  182059 related 24V 3W warning bulb\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 📦 Condition\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Genuine Volvo Penta part\n \u003c\/li\u003e\n \u003cli\u003e\n  Brand new\n \u003c\/li\u003e\n \u003cli\u003e\n  Supplied in original or equivalent packaging\n \u003c\/li\u003e\n\u003c\/ul\u003e\n","brand":"Volvo Penta","offers":[{"title":"Default Title","offer_id":53380939186468,"sku":"862508L","price":175.34,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0994\/8115\/7924\/files\/original_1ae4a19e-4544-47a2-b552-c52a1e3fe6fe.jpg?v=1788053808","url":"https:\/\/www.sawleysautoandmarine.com.au\/products\/1140624-level-sensor-genuine-volvo-penta","provider":"Sawley's Auto and Marine","version":"1.0","type":"link"}