{"product_id":"21107579-engine-bracket-genuine-volvo-penta","title":"21107579 Engine Bracket | Genuine Volvo Penta Part","description":"\u003ch2\u003e\n 🔧 Product Description\n\u003c\/h2\u003e\n\u003cp\u003e\n Brand-new genuine Volvo Penta front starboard engine bracket for D1-20 installations. It is the structural link between the engine block and flexible mounting element and replaces the earlier bracket design used on the same mounting position.\n\u003c\/p\u003e\n\u003ch2\u003e\n 🚤 Compatibility\n\u003c\/h2\u003e\n\u003cp\u003e\n Typically suits:\n\u003c\/p\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Volvo Penta D1-20\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta D1-20B\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta D1-20F\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cul\u003e\n \u003cli\u003e\n  \u003cstrong\u003e\n   Engine Family:\n  \u003c\/strong\u003e\n  D\n \u003c\/li\u003e\n \u003cli\u003e\n  \u003cstrong\u003e\n   HP Range:\n  \u003c\/strong\u003e\n  20 HP\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n ⚙️ Key Features\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Front starboard bracket for D1-20 engines\n \u003c\/li\u003e\n \u003cli\u003e\n  Correct height and offset for the D1 mounting bed\n \u003c\/li\u003e\n \u003cli\u003e\n  Rigid cast construction\n \u003c\/li\u003e\n \u003cli\u003e\n  Related to earlier reference 3819404\n \u003c\/li\u003e\n \u003cli\u003e\n  Bracket only\n \u003c\/li\u003e\n \u003cli\u003e\n  Engine type: Volvo Penta D1 three-cylinder marine diesel\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔌 Function\n\u003c\/h2\u003e\n\u003cp\u003e\n Carries engine load into the starboard flexible mount while preserving the correct engine and driveline alignment.\n\u003c\/p\u003e\n\u003ch2\u003e\n ⚠️ Common Signs of Failure\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Engine sitting low on the starboard side\n \u003c\/li\u003e\n \u003cli\u003e\n  Cracks or distortion around the mount pad\n \u003c\/li\u003e\n \u003cli\u003e\n  Vibration after alignment\n \u003c\/li\u003e\n \u003cli\u003e\n  Loose mounting fasteners\n \u003c\/li\u003e\n \u003cli\u003e\n  Corrosion at the bracket-to-block interface\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🛠️ Service Notes\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Start all the fasteners by hand and get the bracket sitting flat on clean mating faces before tightening anything, so nothing is pulled into strain\n \u003c\/li\u003e\n \u003cli\u003e\n  Renew self-locking nuts, lock washers and thread-locking compound where the original assembly used them, and tighten to the figure given in the workshop manual for your engine\n \u003c\/li\u003e\n \u003cli\u003e\n  Inspect the bracket for cracks around the holes and weld lines before fitting, and do not attempt to straighten or weld a distorted engine bracket back into service\n \u003c\/li\u003e\n \u003cli\u003e\n  Where the bracket forms part of the engine mounting, recheck engine alignment and shaft or drive coupling alignment after the work, following the procedure for your installation\n \u003c\/li\u003e\n \u003cli\u003e\n  Renew any flexible mount, bush or shim pack that is disturbed and found perished, corroded or crushed\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔄 Supersession \u0026amp; Cross Reference\n\u003c\/h2\u003e\n\u003ch3\u003e\n OEM Supersession Chain\n\u003c\/h3\u003e\n\u003cul\u003e\n \u003cli\u003e\n  21107579 → Replaces 3819404\n \u003c\/li\u003e\n \u003cli\u003e\n  3819404 - Earlier OEM bracket reference\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003e\n OEM \/ Related Numbers\n\u003c\/h3\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Earlier reference 3819404\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003e\n Other-Brand OEM Numbers\n\u003c\/h3\u003e\n\u003cul\u003e\n \u003cli\u003e\n  VOE21107579\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 📦 Condition\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Genuine Volvo Penta part\n \u003c\/li\u003e\n \u003cli\u003e\n  Brand new\n \u003c\/li\u003e\n \u003cli\u003e\n  Supplied in original or equivalent packaging\n \u003c\/li\u003e\n\u003c\/ul\u003e\n","brand":"Volvo Penta","offers":[{"title":"Default Title","offer_id":53381816877348,"sku":"D638826","price":640.86,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0994\/8115\/7924\/files\/original_4ab33e29-cece-4b0d-b91a-3169f2361d43.jpg?v=1788059346","url":"https:\/\/www.sawleysautoandmarine.com.au\/products\/21107579-engine-bracket-genuine-volvo-penta","provider":"Sawley's Auto and Marine","version":"1.0","type":"link"}