{"product_id":"22047960-o-ring-genuine-volvo-penta","title":"22047960 O-Ring | Genuine Volvo Penta Part","description":"\u003ch2\u003e\n 🔧 Product Description\n\u003c\/h2\u003e\n\u003cp\u003e\n Elastomer sealing ring used in the TAD5 water-pump and thermostat-housing assembly. It seals the pump or cap interface against coolant pressure and temperature cycling.\n\u003c\/p\u003e\n\u003ch2\u003e\n 🚤 Compatibility\n\u003c\/h2\u003e\n\u003cp\u003e\n Typically suits:\n\u003c\/p\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Volvo Penta TAD840GE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD841-43GE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD552VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD853VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD851-53GE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD880-82GE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD880-84VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD580-83VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD570-72VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD570-71VE-B\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD550-51VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD540-42VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD840-43VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD850-52VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD870-73VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD840GE-B\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TADH880-82GE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TADH880-84VE\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD840-43VE-C\n \u003c\/li\u003e\n \u003cli\u003e\n  Volvo Penta TAD850-52VE-C\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cul\u003e\n \u003cli\u003e\n  \u003cstrong\u003e\n   Engine Family:\n  \u003c\/strong\u003e\n  TAD, TADH\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n ⚙️ Key Features\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Correct cross-section and sealing diameter\n \u003c\/li\u003e\n \u003cli\u003e\n  Coolant-, oil- or fuel-compatible elastomer\n \u003c\/li\u003e\n \u003cli\u003e\n  Designed for the original groove compression\n \u003c\/li\u003e\n \u003cli\u003e\n  Resists temperature and pressure cycling\n \u003c\/li\u003e\n \u003cli\u003e\n  Single-use replacement recommended when disturbed\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔌 Function\n\u003c\/h2\u003e\n\u003cp\u003e\n Forms a pressure-tight seal between mating components and prevents fluid leakage or air entry.\n\u003c\/p\u003e\n\u003ch2\u003e\n ⚠️ Common Signs of Failure\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  External fluid leakage\n \u003c\/li\u003e\n \u003cli\u003e\n  Flattening or permanent compression set\n \u003c\/li\u003e\n \u003cli\u003e\n  Cuts, nicks or pinching during assembly\n \u003c\/li\u003e\n \u003cli\u003e\n  Swelling, hardening or chemical attack\n \u003c\/li\u003e\n \u003cli\u003e\n  Pressure loss or air entry at the joint\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🛠️ Service Notes\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Always fit a new O-ring — never refit one that has been removed, as it has already taken a set in its groove\n \u003c\/li\u003e\n \u003cli\u003e\n  Clean the groove and both sealing faces and check them for nicks, scoring and corrosion pitting; a damaged groove will leak however good the new seal is\n \u003c\/li\u003e\n \u003cli\u003e\n  Smear the ring with a little clean lubricant compatible with the fluid it seals, then roll it into place by hand so it sits untwisted and fully in its groove\n \u003c\/li\u003e\n \u003cli\u003e\n  Never lever an O-ring over a sharp edge or thread with a screwdriver; use a blunt plastic tool and protect any edge the ring has to pass\n \u003c\/li\u003e\n \u003cli\u003e\n  Assemble the joint squarely and tighten to the figure and sequence given in the workshop manual for your engine — over-tightening extrudes the ring and causes the very leak you were curing\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 🔄 Supersession \u0026amp; Cross Reference\n\u003c\/h2\u003e\n\u003ch3\u003e\n OEM \/ Related Numbers\n\u003c\/h3\u003e\n\u003cul\u003e\n \u003cli\u003e\n  22047973 - associated pump\n \u003c\/li\u003e\n \u003cli\u003e\n  22047982 - associated cap\n \u003c\/li\u003e\n \u003cli\u003e\n  3836096 - related\/earlier cap reference\n \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e\n 📦 Condition\n\u003c\/h2\u003e\n\u003cul\u003e\n \u003cli\u003e\n  Genuine Volvo Penta part\n \u003c\/li\u003e\n \u003cli\u003e\n  Brand new\n \u003c\/li\u003e\n \u003cli\u003e\n  Supplied in original or equivalent packaging\n \u003c\/li\u003e\n\u003c\/ul\u003e\n","brand":"Volvo Penta","offers":[{"title":"Default Title","offer_id":53379746562340,"sku":"D629403","price":5.85,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0994\/8115\/7924\/files\/original_f46e0687-5353-405f-ac4f-d4c6c1f06b73.png?v=1788057021","url":"https:\/\/www.sawleysautoandmarine.com.au\/products\/22047960-o-ring-genuine-volvo-penta","provider":"Sawley's Auto and Marine","version":"1.0","type":"link"}