184481 Ball Bearing | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta Ball Bearing - Part Number: 184481

This genuine Volvo Penta ball bearing is a precision rolling-element or raceway component used in the serial-controlled heavy-duty rotating-shaft ball-bearing position. It is manufactured to the original Volvo dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. Documented outside diameter: approximately 150 mm. Double-sealed radial ball-bearing configuration. In service, it supports the selected rotating shaft with sealed deep-groove rolling contact. Selection must be confirmed by OEM part number 184481, the exact engine/product model, serial number and installed configuration.

⚙️ Key Features

• Genuine Volvo Penta OEM ball bearing

• OEM part number 184481

• Documented application: serial-controlled heavy-duty rotating-shaft ball-bearing position

• Validated family: Volvo Penta marine or industrial driveline

• Documented outside diameter: approximately 150 mm

• Double-sealed radial ball-bearing configuration

• Primary function: Supports the selected rotating shaft with sealed deep-groove rolling contact.

• Measure shaft and housing fits, renew contaminated lubricant and related seals, and install using force only through the race being fitted. Set preload or end float to the applicable Volvo Penta specification.

🔄 Supersession & Cross Reference

OEM Supersession Chain:

• 184481 (current/original OEM service reference)

OEM / Related Numbers:

• 184481

Aftermarket / Verified Equivalents:

• No aftermarket equivalent

🚤 Compatibility

Commonly used on:

• serial-controlled heavy-duty rotating-shaft ball-bearing position

Typically suits:

• Engine / product models:

• Assemblies specifying sealed ball bearing 184481

• Engine / Application Family: Volvo Penta marine or industrial driveline

• Serial / Configuration Note: Confirm part number 184481 against the exact drive, transmission or engine serial number, bearing location and installed shaft/housing arrangement; adjacent gear ratios and production variants may use different race dimensions or preload components.

🔌 Function

Supports the selected rotating shaft with sealed deep-groove rolling contact. Measure shaft and housing fits, renew contaminated lubricant and related seals, and install using force only through the race being fitted. Set preload or end float to the applicable Volvo Penta specification.

Common signs of failure:

• Rumbling, growling, clicking or cyclic rotational noise

• Excessive radial or axial play measured at the supported shaft

• Localised heat, lubricant discolouration or burnt odour at the bearing position

• Pitting, brinelling, flaking, corrosion or scoring on rollers and raceways

• Vibration, shaft run-out or repeated seal/gear wear caused by loss of alignment

📦 Condition

• Genuine Volvo Penta part

• Brand new

• Supplied in original or equivalent packaging