20513745 Ring | Genuine Volvo Penta Part
20513745 Ring | Genuine Volvo Penta Part
Couldn't load pickup availability
🔧 Product Description
This genuine Volvo Penta ring is an OEM service component used in the Rigid-Pipe Compression Cutting Ring. It is manufactured to the original Volvo Penta dimensional, material and interface requirements for the documented Volvo/Volvo Penta engine fuel, oil and coolant-line fittings application. Technical identification: Single-use compression cutting ring for a matched rigid pipe and union; approximate listed weight 0.004 kg; Volvo product group 2520, function group 1159. In service, it compresses into the matched union to grip and seal the rigid pipe connection. Selection must be confirmed by OEM part number 20513745, the exact model/product number, serial number and installed assembly configuration.
⚙️ Key Features
- Genuine Volvo Penta OEM ring
- OEM part number 20513745
- Technical distinction: Single-use compression cutting ring for a matched rigid pipe and union; approximate listed weight 0.004 kg; Volvo product group 2520, function group 1159
🔌 Function
Compresses into the matched union to grip and seal the rigid pipe connection. Clean and inspect both sealing surfaces, renew the seal whenever the joint is opened, avoid twisting or cutting and tighten the joint evenly to specification.
⚠️ Common Signs of Failure
- Visible oil, coolant, fuel or air leakage at the sealed joint
- Loss of pressure, vacuum or fluid level in the connected system
- Contamination passing across the seal or entering the assembly
- Seal hardened, cut, swollen, flattened or displaced
- Repeat leakage caused by a damaged groove, shaft or mating face
🛠️ Service Notes
- Renew rather than reuse: rings of this kind seal or retain by being sprung or compressed into place and take a permanent set once fitted
- Clean the groove, register or bore the ring sits in and remove any burr or old sealing residue before fitting — debris in the groove stops a ring seating and is a common cause of a repeat leak
- Open or compress the ring only as far as it needs to go on; overstretching or twisting it during fitting distorts it permanently
- Check the ring is fully seated all the way round its groove or register, and the right way round where its faces differ, before closing the assembly up
📦 Condition
- Genuine Volvo Penta part
- Brand new
- Supplied in original or equivalent packaging
Share
