23190000 Wiring Harness | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta 7 metre cable, listed as the required lead between the engine and the tachometer in the instrument range for non-EVC petrol engines — the 85 mm tachometers 23040335 and 23040364 will not work without it. It weighs 2.223 kg and supersedes 22894884, catalogued earlier as a wiring harness.

⚙️ Key Features

• 7 metres long
• Required between engine and tachometer
• For the non-EVC petrol tachometers 23040335 and 23040364
• 2.223 kg
• Supersedes 22894884, catalogued earlier as a wiring harness
• 7 m long
• Required with the non-EVC gasoline tachometers
• Length: 7 m
• Fits: non-EVC gasoline engine tachometers 23040335 and 23040364

🔌 Function

Carries the engine's signal and supply over a 7 metre run to the tachometer, which in turn feeds the instruments connected to its easy-link gateway.

⚠️ Common Signs of Failure

• Tachometer dead or dropping out, particularly under way
• Voltage measured lower at the tachometer end than at the engine
• Corrosion or green crusting at a terminal or connector pin
• Insulation chafed through at a bulkhead or a clip
• Connector discoloured from heat at a poor joint

🛠️ Service Notes

• It is a required part of a non-EVC petrol tachometer installation, not an optional extra, and is not supplied with the instrument
• Measure the routing before ordering — 7 metres is the defining specification, and a run that is too short cannot be made good
• Support the cable at intervals and keep it clear of hot surfaces and sharp edges rather than relying on the old clips
• Required - the tachometer will not work without it

🔄 Supersession & Cross Reference

OEM Supersession Chain

• 23190000 → Supersedes 22894884

OEM / Related Numbers

• 22894884 earlier number superseded by this part

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging