1275404 Gasket | Genuine Volvo Penta Part

🔧 Product Description

This is a genuine Volvo Penta gasket from the lubricating and oil system group for D3 series marine diesel engines. It provides the sealing interface at an oil system joint, keeping lubricating oil contained and preventing seepage at the mating faces. Gaskets of this type are single-use items and should be renewed whenever the joint they seal is disturbed during service.

🚤 Compatibility

• Engine Family: D
• HP Range: 110-220 HP
• Year Range: Approximately 2004-2014, depending on D3 suffix and oil-pump revision

Full model list at the end of this description.

⚙️ Key Features

• OEM Volvo Penta part number 1275404
• System group: Lubricating and Oil System
• Fits D3 series marine diesel engines, including D3-110 through D3-220 inboard and sterndrive variants
• Supplied as an individual sealing gasket, intended for replacement rather than reuse
• Engine type: Volvo Penta 2.4L inline 5-cylinder common-rail marine diesel

🔌 Function

The gasket forms a static seal between two mating surfaces in the engine's lubricating oil circuit, maintaining oil pressure and preventing leakage. Renewing it on reassembly restores the correct sealing face and protects against oil loss.

⚠️ Common Signs of Failure

• Visible oil weeping or dripping from the joint the gasket seals
• Falling oil level or oil residue accumulating below the sealing face
• Hardened, cracked, brittle or flattened gasket material found on inspection
• Loss of oil pressure or air being drawn into the oil circuit at the joint
• Gasket tears or distorts on removal, making reuse impossible

🛠️ Service Notes

• Fit a new gasket every time the joint is disturbed — a gasket takes a permanent set once it has been torqued and will not seal reliably a second time
• Scrape both faces back to clean bare metal, keeping the blade at a shallow angle so it lifts the old material without gouging the surface, and use a plastic scraper on aluminium castings
• Check the faces for flatness, cracks and corrosion pitting, and make sure no old gasket, carbon or hardened sealant is left in the corners or around the bolt holes
• Fit the gasket dry unless the workshop manual for your engine calls for a sealant, and then only the type it specifies — surplus sealant squeezes out into oil, coolant and fuel passages
• Draw the fasteners down progressively in the sequence and to the torque given in the manual for your engine, and recheck after the first heat cycle where the manual asks for it

🔄 Supersession & Cross Reference

OEM / Related Numbers

• 30637377 related early oil pump, through engine serial 334746
• 30777092 related later oil pump, from engine serial 334747
• 30677893 related early piston-cooling valve, through engine serial 350113
• 30750943 related later piston-cooling valve, from engine serial 350114
• 981204 related oil pump O-ring

Other-Brand OEM Numbers

• Elring: 510.390

Aftermarket / Verified Equivalents

• Skandix catalogue reference: 1013694
• Ajusa: 01028800
• Payen: KF0012
• Elwis Royal: 7055513

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta D3-110I-B, D3-110I-C, D3-130I-C, D3-220I-G, D3-130A-A, D3-160A-A, D3-130A-B, D3-160A-B, D3-130A-C, D3-160A-C, D3-140A-D, D3-170A-D, D3-200A-D, D3-220A-D, D3-140I-D, D3-140A-E, D3-170A-E, D3-200A-E, D3-220A-E, D3-140I-E, D3-140A-F, D3-170A-F, D3-200A-F, D3-220A-F, D3-140I-F, D3-140A-G, D3-170A-G, D3-200A-G, D3-220A-G, D3-140I-G, D3-190A-B, D3-190A-C, D3-190I-A, D3-110I-A, D3-130I-A, D3-160I-A, D3-110I-D, D3-150I-D, D3-170I-D, D3-200I-D, D3-220I-D, D3-110I-E, D3-150I-E, D3-170I-E, D3-200I-E, D3-220I-E, D3-110I-F, D3-150I-F, D3-170I-F, D3-200I-F, D3-220I-F, D3-110I-G, D3-150I-G, D3-170I-G, D3-200I-G, D3-160I-C, D3-190I-B, D3-190I-C, D3-130I-B, D3-160I-B