1556208 Cover | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta cover is a machined connection, housing or closure component used in the timing-gear casing. It is manufactured to the original Volvo Penta dimensions and interface requirements so the adjoining component remains supported, located and sealed at the housing or closure. In service, it closes the timing-gear casing opening and protects the gear train while retaining lubricating oil. Fitment is controlled by the exact engine or product configuration and serialised parts list; confirm OEM number 1556208 against the installed assembly before ordering.

🚤 Compatibility

• Engine Family: D, TWD, TAD

Full model list at the end of this description.

⚙️ Key Features

• OEM Volvo Penta part number 1556208
• System group: Engine
• Net weight approximately 1.04 kg
• Fits D12 series marine diesel engines and TWD1240/TAD1240-TAD1252 industrial and genset engines
• Supplied as an individual component

🔌 Function

The cover seals and encloses an opening in the engine assembly, retaining internal fluids and keeping dirt, water and debris out of the housing. It also provides a serviceable access point for inspection and maintenance of the components behind it.

⚠️ Common Signs of Failure

• Oil or coolant seepage along the sealing face or around the fasteners
• Cracks, impact damage or corrosion pitting on the cover body
• Warped or distorted sealing flange preventing an even gasket seal
• Damaged, stripped or elongated bolt holes causing loose mounting
• Repeated gasket failure at the same joint despite correct torque

🛠️ Service Notes

• Clean both sealing faces back to clean metal and check the cover for distortion, cracks or pulled bolt holes before refitting — a warped flange will not seal even with a new gasket
• Where the joint uses a gasket, seal or O-ring, always fit a new one and seat it dry unless the workshop manual for your engine specifies a sealant; never try to make a poor joint tight with extra sealant
• Tighten the fasteners progressively and evenly, working out from the centre, to the figure given in the manual for your engine — pressed steel, alloy and plastic covers distort easily if pulled down hard or unevenly
• If the cover carries a shaft seal or bearing, support it square to the shaft as it goes on so the seal lip is not nicked or rolled over
• Check that any breather, drain or oil return passage in the cover is clear before final tightening, and look for leaks once the engine has been run up to temperature

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta D12C-A MP, D12D-A MG, D12D-A MH, D12D-A MP, D12D-B MH, D12D-B MP, D12D-C MH, D12D-C MP, D12D-D MP, D12D-E MG, D12D-E MH, D12D-E MP, D12D-F MP, D12D-G MH, D12D-G MP, D12D-H MP
• Volvo Penta TAD1241GE, TAD1241VE, TAD1241-42VE
• Volvo Penta TAD1242GE, TAD1242VE
• Volvo Penta TAD1250VE, TAD1250-52VE
• Volvo Penta TAD1240GE
• Volvo Penta TAD1251VE
• Volvo Penta TAD1252VE
• Volvo Penta TWD1240VE