1560272 Spacer Washer | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta spacer washer is a replaceable locating, spacing or bearing-support component used in the belt-protector and bracket installation. It is manufactured to the original Volvo Penta dimensions and interface requirements so the supported component retains the specified clearance, spacing and location. Spacer washer dimensions: approximately 18 mm OD × 8.4 mm ID × 13 mm long. In service, it sets the required spacing and load distribution beneath the matched belt-protector fastener. Fitment is controlled by the exact engine or product configuration and serialised parts list; confirm OEM number 1560272 against the installed assembly before ordering.

🚤 Compatibility

• Engine Family: TAMD, TWD, TD, TAD

Full model list at the end of this description.

⚙️ Key Features

• OEM Volvo Penta part number 1560272
• Dimension: 18x8,4x13mm (outer diameter x bore x length)
• System group: Inlet and Exhaust System
• Net weight approximately 0.016 kg
• Fits TAMD, TAD, TWD and TD series marine and industrial diesel engines
• Quantity varies by assembly, most commonly two

🔌 Function

The spacer washer establishes a fixed distance between two mating surfaces or between a fastener and a component, preventing over-compression and holding assembly alignment. It also spreads fastener load across the joint face.

⚠️ Common Signs of Failure

• Visible crushing, deformation or flattening of the spacer
• Loose or repeatedly loosening fasteners at the joint
• Misalignment or uneven seating of the mounted component
• Corrosion, pitting or seizure onto the bolt or stud
• Exhaust or intake leakage traced to incorrect joint spacing

🛠️ Service Notes

• A spacer washer sets a dimension as well as carrying load — keep or measure the original and refit the same thickness unless the workshop manual for your engine tells you to select a different one
• Refit spacers in the same order and the same positions they came from, and keep them with their own assembly while it is apart
• Check both faces for wear, dishing, burrs and fretting marks, and fit a new washer if the faces are no longer flat and parallel
• Make sure the seating faces are clean before assembly; grit or old sealant under a spacer changes the very clearance it is there to set
• Where the spacer sets an endfloat or a clearance, measure that clearance after assembly against the manual figure rather than assuming it

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta TAMD74P-A, TAMD74P-B, TAMD74A, TAMD74C-A, TAMD74C-B, TAMD74L-A, TAMD74L-B
• Volvo Penta TAMD63L-A, TAMD63P-A
• Volvo Penta TAMD72P-A, TAMD72WJ-A
• Volvo Penta TAMD73P-A, TAMD73WJ-A
• Volvo Penta TWD740GE, TWD740VE
• Volvo Penta TAD730G
• Volvo Penta TAD740GE
• Volvo Penta TAD741GE
• Volvo Penta TAMD71B
• Volvo Penta TAMD75P-A
• Volvo Penta TD610G
• Volvo Penta TD710G
• Volvo Penta TWD610G
• Volvo Penta TWD710G