1675599 Cover | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta cover is a protective housing/guard component used in the inlet/exhaust-system cover. It is manufactured to the original Volvo dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. In service, it closes and protects the designated inlet/exhaust-system opening while preserving the system seal. Selection must be confirmed by OEM part number 1675599, the exact engine/product model, serial number and the installed assembly configuration.

🚤 Compatibility

Typically suits:

• Volvo Penta TAD740GE
• Volvo Penta TAD741GE
• Volvo Penta TAMD74A

• Engine Family: TAD, TAMD

⚙️ Key Features

• OEM Volvo Penta part number 1675599
• System group: Cooling System
• Net weight: 0.55 kg
• Fits TAD740GE, TAD741GE and TAMD74A engines
• Supplied as a genuine Volvo Penta replacement component

🔌 Function

The cover seals an opening in the engine's cooling system housing, containing coolant and maintaining correct system pressure. It also provides service access to the internal cooling passages behind it.

⚠️ Common Signs of Failure

• Coolant seepage or drips around the cover joint face
• Loss of cooling system pressure and repeated coolant top-ups
• Corrosion, pitting or scaling on the sealing surface
• Warped or cracked cover preventing an even seal
• Overheating or fluctuating coolant temperature caused by a leaking seal

🛠️ Service Notes

• Clean both sealing faces back to clean metal and check the cover for distortion, cracks or pulled bolt holes before refitting — a warped flange will not seal even with a new gasket
• Where the joint uses a gasket, seal or O-ring, always fit a new one and seat it dry unless the workshop manual for your engine specifies a sealant; never try to make a poor joint tight with extra sealant
• Tighten the fasteners progressively and evenly, working out from the centre, to the figure given in the manual for your engine — pressed steel, alloy and plastic covers distort easily if pulled down hard or unevenly
• If the cover carries a shaft seal or bearing, support it square to the shaft as it goes on so the seal lip is not nicked or rolled over
• Check that any breather, drain or oil return passage in the cover is clear before final tightening, and look for leaks once the engine has been run up to temperature

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging