17240549 Timing Gear Plate | Genuine Volvo Penta Part
17240549 Timing Gear Plate | Genuine Volvo Penta Part
Couldn't load pickup availability
Available on request — contact us
As an authorised Volvo Penta dealer we can source parts through channels not shown online, and check supersession and used options for you
Availability checked daily with Volvo Penta
✓ Authorised Volvo Penta Dealer · Genuine Volvo Penta parts · Ships Australia-wide
🔧 Product Description
Genuine Volvo Penta timing gear plate, forming the mounting face and location for the engine's timing gear train. It is listed for a TAD-series industrial diesel engine application. Accurate gear plate condition is essential for correct gear mesh and timing.
🚤 Compatibility
Typically suits:
- Volvo Penta TAD1170-72VE
- Engine Family: TAD
⚙️ Key Features
- Machined timing-gear housing / control plate
- Confirmed for TAD1170-72VE engine arrangements
- Installed in the flywheel-housing and timing-gear assembly
- Provides mounting and alignment for timing-drive components
- Requires the specified sealant 1161277 and correct tightening sequence
- Engine type: Volvo Penta 11-litre industrial diesel
🔌 Function
The timing gear plate carries the bearing and location points for the timing gears, holding them at the correct centre distances so the gear train meshes properly. It also forms part of the sealed enclosure around the gear train.
⚠️ Common Signs of Failure
- Timing gear noise, whine or rattle from incorrect mesh
- Oil leakage at the gear plate joint faces
- Wear, ovality or scoring at the gear location bores
- Cracking around mounting or dowel positions
- Distortion of the sealing face causing a persistent leak
🛠️ Service Notes
- Clean both faces completely and check the plate for flatness before refitting; this seals against a machined face, so any sealant ridge or burr will leak oil
- Take care of the locating dowels or bushes — the plate positions the timing components, so it must go back on its locations rather than be centred on its bolts
- Renew the gasket and any seal carried in the plate, and apply sealant only where the workshop manual for your engine specifies
- Tighten evenly in stages to the manual's figures and sequence, then turn the engine over by hand and check the timing gears run freely with the correct backlash before starting
- Have the front seal and a full gasket set to hand before you begin — the plate rarely comes off without disturbing the parts around it
🔄 Supersession & Cross Reference
OEM / Related Numbers
- 17463337 - flywheel housing
- 11127857 - related gears
- 11127950 - related gears
- 11127858 - related shaft
- 4804167 - cover gasket
- 4772168 - cover
- 1161277 - specified sealant
📦 Condition
- Genuine Volvo Penta part
- Brand new
- Supplied in original or equivalent packaging
Shipping & Delivery
Shipping & Delivery
Flat-rate shipping Australia-wide — $14.99 per order, no matter how many parts you add. Orders dispatch from our Kadina, South Australia store. Need it urgently or want to collect in person? Call us on 0412 532 984 before ordering.
Returns & Warranty
Returns & Warranty
14-day change-of-mind returns — if it's not right or you ordered the wrong part, send it back within 14 days in new, unused condition for a refund or exchange. Manufacturer warranties apply to new parts. Full details in our Refunds & Returns policy.
Not sure this fits?
Not sure this fits?
Ask us before you buy — we check part numbers and fitment every day. Call 0412 532 984 (Mon–Fri 8.30am–4.30pm) or message us through the contact page with your engine or vehicle details.
Share
