18344 Clamp | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta clamp is an OEM hose, pipe or cable retention component used in the turbocharger and air-filter vent-pipe clamping position. It is manufactured to the original Volvo dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. Two clamps are specified in the documented replacement arrangement. In service, it secures the turbo/air-filter vent pipe against vibration and movement at the documented mounting points. Selection must be confirmed by OEM part number 18344, the exact engine/product model, serial number and installed configuration.

⚙️ Key Features

• Genuine Volvo Penta OEM clamp
• OEM part number 18344
• Two clamps are specified in the documented replacement arrangement
• Position the clamp at the original support point without crushing the hose or pipe, renew damaged cushioning or hardware, and verify clearance throughout engine movement and vibration.

🔌 Function

Secures the turbo/air-filter vent pipe against vibration and movement at the documented mounting points. Position the clamp at the original support point without crushing the hose or pipe, renew damaged cushioning or hardware, and verify clearance throughout engine movement and vibration.

⚠️ Common Signs of Failure

• Corrosion or rust weakening the clamp band
• Leakage or seepage at the clamped joint
• Clamp no longer holding tension when tightened
• Pipe or hose able to move or twist at the connection
• Distorted or cracked clamp on removal

🛠️ Service Notes

• Fit a new clamp rather than reusing one that has been distorted, stretched or corroded; a band that has been drawn down onto a hose once rarely grips evenly again
• Use the correct size and type for the joint — an over-large clamp will not draw down evenly and can cut into a soft hose instead of gripping it
• Position the clamp fully over the spigot or pipe bead, clear of the hose end, and tighten only until the joint is secure; over-tightening crushes hoses, pipes and cable insulation
• Set the screw or head where you can reach it for later checks, and make sure the clamp is not resting anywhere it will chafe a neighbouring hose or harness
• Re-check tightness after the first run up to temperature, as hoses relax and settle once they have been heated

🔄 Supersession & Cross Reference

OEM Supersession Chain

• 18344 → Supersedes 845413

OEM / Related Numbers

• 845033 earlier number superseded by this part
• 845413 earlier number superseded by this part
• 846215 replacement vent pipe
• 846216 hollow screw (quantity 2)
• 957174 gasket (quantity 2)
• 957175 gasket (quantity 2)

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging