184816 Ball Bearing | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta Ball Bearing - Part Number: 184816

This genuine Volvo Penta ball bearing is a precision ball bearing engineered to support a rotating shaft with low friction and controlled radial alignment used in the coolant-pump, fan-pulley or accessory-drive assembly. It is manufactured to the original Volvo Penta dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. In service, it supports the pump or pulley shaft and maintains belt and impeller alignment. Selection must be confirmed by OEM part number 184816, the exact engine or product model, serial number and installed configuration.

⚙️ Key Features

• Genuine Volvo Penta OEM ball bearing

• OEM part number 184816

• Application: coolant-pump, fan-pulley or accessory-drive assembly

• Engine / drive family: Volvo Penta 10- and 16-litre cooling/accessory drives

• Primary function: Supports the pump or pulley shaft and maintains belt and impeller alignment.

• Use the correct press tools and support the loaded race during installation; verify shaft fit, housing fit, lubrication and any specified end-float setting.

🔄 Supersession & Cross Reference

OEM Supersession Chain:

• 184816 → Supersedes 183894

OEM / Related Numbers:

• 184816

• 183894

• 1660057 pulley

• 1675846 pulley

• 1675868 pulley

• 862338 and 8193578 thermostat/cooling housings

Aftermarket / Verified Equivalents:

• No aftermarket equivalent

🚤 Compatibility

Commonly used on:

• coolant-pump, fan-pulley or accessory-drive assembly

Typically suits:

• Engine / product models:

• TAMD162C and related 16-litre variants

• TAD/TWD industrial engines using pulleys 1660057, 1675846 or 1675868

• TWD1031VE where shown

• Engine / Application Family: Volvo Penta 10- and 16-litre cooling/accessory drives

• Serial / Configuration Note: Confirm the exact pump or pulley assembly because the same bearing is used in more than one serialised installation.

🔌 Function

Supports the pump or pulley shaft and maintains belt and impeller alignment. Use the correct press tools and support the loaded race during installation; verify shaft fit, housing fit, lubrication and any specified end-float setting.

Common signs of failure:

• Whining, rumbling or roughness that changes with rotational speed

• Excessive radial or axial play at the supported shaft

• Pitted races, damaged balls, cage wear or heat discolouration

• Rising housing temperature or lubricant contamination

• Shaft misalignment causing seal wear, belt tracking problems or gear noise

📦 Condition

• Genuine Volvo Penta part

• Brand new

• Supplied in original or equivalent packaging