191296 Clamp | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta clamp is a formed retaining clamp designed to secure the specified hose, duct, pipe or cable used in the engine hose or pipe support, function group 1162. It is manufactured to the original Volvo Penta dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. In service, it supports and restrains the specified hose or pipe against vibration and chafing. Selection must be confirmed by OEM part number 191296, the exact engine or product model, serial number and installed configuration.

🚤 Compatibility

• Engine Family: TWD, TID, TD, D, TAD

Full model list at the end of this description.

⚙️ Key Features

• Genuine Volvo Penta OEM clamp
• OEM part number 191296
• Position behind the hose bead or at the original support point, tighten evenly and avoid cutting or crushing the retained component.
• Quantity varies by assembly, most commonly two

🔌 Function

Supports and restrains the specified hose or pipe against vibration and chafing. Position behind the hose bead or at the original support point, tighten evenly and avoid cutting or crushing the retained component.

⚠️ Common Signs of Failure

• Fluid, boost-air or exhaust leakage at the clamped joint
• Clamp loosening, cracking, corrosion or heat damage
• Hose or duct movement under load
• Chafing, fretting or local crushing beneath the clamp
• Repeated connection failure caused by a damaged hose bead or incorrect clamp position

🛠️ Service Notes

• Fit a new clamp rather than reusing one that has been distorted, stretched or corroded; a band that has been drawn down onto a hose once rarely grips evenly again
• Use the correct size and type for the joint — an over-large clamp will not draw down evenly and can cut into a soft hose instead of gripping it
• Position the clamp fully over the spigot or pipe bead, clear of the hose end, and tighten only until the joint is secure; over-tightening crushes hoses, pipes and cable insulation
• Set the screw or head where you can reach it for later checks, and make sure the clamp is not resting anywhere it will chafe a neighbouring hose or harness
• Re-check tightness after the first run up to temperature, as hoses relax and settle once they have been heated

🔄 Supersession & Cross Reference

OEM Supersession Chain

• 191296 → Supersedes 3828663

OEM / Related Numbers

• 966860 earlier number superseded by this part

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta TWD710G, TWD710P, TWD710PB, TWD710V
• Volvo Penta TAD730G, TAD730P, TAD730V
• Volvo Penta TWD610P, TWD610PB, TWD610V
• Volvo Penta D100A, D100B
• Volvo Penta TD71A, TD71AP
• Volvo Penta TWD740GE, TWD740VE
• Volvo Penta TAD740GE
• Volvo Penta TAD741GE
• Volvo Penta TD100A
• Volvo Penta TD40A
• Volvo Penta TD520VE
• Volvo Penta TD610V
• Volvo Penta TD640VE
• Volvo Penta TD720VE PP
• Volvo Penta TID71AP
• Volvo Penta TWD630VE
• Volvo Penta TWD731VE