191992 Clamp | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta clamp is a formed retaining clamp designed to secure the specified hose, duct, pipe or cable used in the engine hose, cable or pipe support. It is manufactured to the original Volvo Penta dimensional, material and interface requirements so the serviced assembly retains its designed alignment, sealing, load capacity and operating reliability. In service, it restrains the selected hose, cable or pipe and prevents vibration damage. Selection must be confirmed by OEM part number 191992, the exact engine or product model, serial number and installed configuration.

🚤 Compatibility

Typically suits:

• Volvo Penta TMD40A
• Volvo Penta TMD40B
• Volvo Penta TMD40C
• Volvo Penta AQAD40B
• Volvo Penta TWD1230VE
• Volvo Penta AQD70C
• Volvo Penta TD70B
• Volvo Penta AQAD40A
• Volvo Penta AQD40A
• Volvo Penta TAMD40A
• Volvo Penta TAMD40B
• Volvo Penta TAMD70C

• Engine Family: TMD, AQAD, TWD, AQD, TD, TAMD
• Serial Range: MO-XXXX/22342

⚙️ Key Features

• Genuine Volvo Penta OEM clamp
• OEM part number 191992
• Position behind the hose bead or at the original support point, tighten evenly and avoid cutting or crushing the retained component.

🔌 Function

Restrains the selected hose, cable or pipe and prevents vibration damage. Position behind the hose bead or at the original support point, tighten evenly and avoid cutting or crushing the retained component.

⚠️ Common Signs of Failure

• Fluid, boost-air or exhaust leakage at the clamped joint
• Clamp loosening, cracking, corrosion or heat damage
• Hose or duct movement under load
• Chafing, fretting or local crushing beneath the clamp
• Repeated connection failure caused by a damaged hose bead or incorrect clamp position

🛠️ Service Notes

• Fit a new clamp rather than reusing one that has been distorted, stretched or corroded; a band that has been drawn down onto a hose once rarely grips evenly again
• Use the correct size and type for the joint — an over-large clamp will not draw down evenly and can cut into a soft hose instead of gripping it
• Position the clamp fully over the spigot or pipe bead, clear of the hose end, and tighten only until the joint is secure; over-tightening crushes hoses, pipes and cable insulation
• Set the screw or head where you can reach it for later checks, and make sure the clamp is not resting anywhere it will chafe a neighbouring hose or harness
• Re-check tightness after the first run up to temperature, as hoses relax and settle once they have been heated

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging