20553463 Sensor | Genuine Volvo Penta Part
20553463 Sensor | Genuine Volvo Penta Part
Couldn't load pickup availability
In stock — Australian warehouse
Typically reaches our store in 3–5 business days
Availability checked daily with Volvo Penta
✓ Authorised Volvo Penta Dealer · Genuine Volvo Penta parts · Ships Australia-wide
🔧 Product Description
This genuine Volvo Penta sensor is an OEM service component used in the Charge-Air Pressure / Temperature and Air-Filter Monitoring Sensor. It is manufactured to the original Volvo Penta dimensional, material and interface requirements for the documented Volvo Penta D5A/D7C industrial diesel application. Technical identification: Combined charge-air pressure/temperature sensor used in the intake-monitoring circuit; documented service-temperature range approximately -40°C to +120°C. In service, it measures the specified engine speed, position, pressure or temperature condition and sends the corresponding signal to the instrument or engine-control system. Selection must be confirmed by OEM part number 20553463, the exact model/product number, serial number and installed assembly configuration.
🚤 Compatibility
- Engine Family: D, TD, TAD, MD
Full model list at the end of this description.
⚙️ Key Features
- Genuine Volvo Penta OEM sensor
- OEM part number 20553463
- Technical distinction: Combined charge-air pressure/temperature sensor used in the intake-monitoring circuit; documented service-temperature range approximately -40°C to +120°C
- Inspect the connector and target/port, install to the specified depth and torque, then verify live-data response and stored fault codes.
🔌 Function
Measures the specified engine speed, position, pressure or temperature condition and sends the corresponding signal to the instrument or engine-control system. Inspect the connector and target/port, install to the specified depth and torque, then verify live-data response and stored fault codes.
⚠️ Common Signs of Failure
- Fault codes, alarms or an implausible live-data/instrument reading
- Intermittent signal loss caused by vibration, heat or connector movement
- Poor starting, derating or unstable engine control
- Open circuit, short circuit or out-of-range resistance/voltage
- Corroded terminals, damaged wiring or a cracked sensor body
🛠️ Service Notes
- Note how the sensor sits and how its lead is routed before removing it, and support the harness so refitting does not leave the cable strained or rubbing
- Turn the sensor with a spanner on its hex only — never lever or twist it by the connector body or the wiring, which breaks the internal joint even when the sensor looks undamaged
- Renew the O-ring or sealing washer where one is fitted, and do not add thread sealant unless the manual for your engine specifies it; sealant on the threads can break the earth path of a sensor that earths through its body
- Tighten to the figure in the workshop manual for your engine — overtightening distorts the housing and shifts or destroys the sensing element
- Make sure the connector is clean, dry and fully latched home and check the pins for corrosion and spread — a poor connector accounts for a great many faults blamed on the sensor — then run the engine and confirm the reading or warning lamp behaves sensibly before returning the boat to service
🔄 Supersession & Cross Reference
OEM Supersession Chain
- 20553463 → Supersedes 20451286
OEM / Related Numbers
- 20451286 earlier number superseded by this part
Other-Brand OEM Numbers
- Deutz: 04214103
Aftermarket / Verified Equivalents
- Hi-TTS: 4214103
📦 Condition
- Genuine Volvo Penta part
- Brand new
- Supplied in original or equivalent packaging
🔎 Full Model Compatibility
Typically suits:
- Volvo Penta D7A-B TA, D7A-T, D7A-TA, D7C-B TA, D7C-TA
- Volvo Penta D5A-B TA, D5A-T, D5A-TA
- Volvo Penta MD2010, MD2010B
- Volvo Penta TAD520GE, TAD520VE
- Volvo Penta TAD530GE MECH, TAD530GE EDC4
- Volvo Penta TAD531GE MECH, TAD531GE EDC4
- Volvo Penta TAD720GE, TAD720VE
- Volvo Penta TAD721GE, TAD721VE
- Volvo Penta TAD722GE, TAD722VE
- Volvo Penta TAD730GE MECH, TAD730GE EDC4
- Volvo Penta TAD731GE MECH, TAD731GE EDC4
- Volvo Penta TD520GE, TD520VE
- Volvo Penta TD720GE, TD720VE PP
- Volvo Penta TAD420VE
- Volvo Penta TAD532GE EDC4
- Volvo Penta TAD550GE
- Volvo Penta TAD551GE
- Volvo Penta TAD620VE
- Volvo Penta TAD732GE EDC4
- Volvo Penta TAD733GE EDC4
- Volvo Penta TD420VE
Shipping & Delivery
Shipping & Delivery
Flat-rate shipping Australia-wide — $14.99 per order, no matter how many parts you add. Orders dispatch from our Kadina, South Australia store. Need it urgently or want to collect in person? Call us on 0412 532 984 before ordering.
Returns & Warranty
Returns & Warranty
14-day change-of-mind returns — if it's not right or you ordered the wrong part, send it back within 14 days in new, unused condition for a refund or exchange. Manufacturer warranties apply to new parts. Full details in our Refunds & Returns policy.
Not sure this fits?
Not sure this fits?
Ask us before you buy — we check part numbers and fitment every day. Call 0412 532 984 (Mon–Fri 8.30am–4.30pm) or message us through the contact page with your engine or vehicle details.
Share
