21098844 Cable | Genuine Volvo Penta Part

🔧 Product Description

A genuine Volvo Penta pre-terminated electrical cable manufactured for a specific engine or installation harness connection. The cable is supplied with the conductor size, insulation, terminal style and overall length required by its assigned circuit. Because Volvo Penta cable numbers can differ by system voltage, installation layout and terminal orientation, selection must be made from the complete product number and serial-number-controlled wiring parts list for your engine from serial number 01071393 onwards.

🚤 Compatibility

Typically suits:

• Volvo Penta TD420VE
• Volvo Penta TAD420VE

• Engine Family: TD, TAD
• Serial Range: SN01071393-

⚙️ Key Features

• Factory-terminated cable with application-specific end fittings
• Conductor cross-section selected for the assigned current load and voltage drop
• Oil-, heat- and abrasion-resistant engine-compartment insulation
• Terminal orientation and cable length match the original routing
• Not interchangeable with a visually similar battery, starter or bonding cable without parts list for your engine confirmation
• Engine type: Serial-controlled Volvo Penta electrical installation

🔌 Function

Carries electrical current or system bonding continuity between the two designated connection points while maintaining low resistance and safe insulation within the engine compartment.

⚠️ Common Signs of Failure

• Voltage drop or slow operation of the connected electrical component
• Heat discolouration at a terminal or cable end
• Corrosion inside the crimped terminal
• Cracked, hardened or abraded insulation
• Intermittent operation when the cable is moved or loaded

🛠️ Service Notes

• Isolate the battery before disconnecting or reconnecting anything, and make sure connectors are clean, dry and fully latched before switching the system back on
• Route the new cable along the original path and secure it with the original clips, ties and stand-offs; unsupported cable chafes through wherever it touches a bracket, hose or edge
• Keep the run clear of the exhaust and turbocharger, away from moving parts and sharp edges, and use a grommet or gland wherever it passes through a panel or bulkhead
• Protect the connections against damp — a properly seated and sealed connector survives an engine bilge atmosphere far better than a taped joint
• Replace a damaged cable rather than patching it; where a repair is unavoidable use a crimped and sealed joint, never solder as the only mechanical connection

🔄 Supersession & Cross Reference

Other-Brand OEM Numbers

• VOE21098844

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging