21112764 Intermediate Plate | Genuine Volvo Penta Part

🔧 Product Description

A genuine Volvo Penta intermediate plate engineered for a marine transmission or flywheel-housing mounting stack. This component is a thin intermediate plate establishing component spacing and a flat mounting interface. Correct selection requires the complete Volvo Penta product number and serial number because adjoining components, mounting arrangements and production revisions can change within the same engine or transmission family.

⚙️ Key Features

• Controlled thickness establishes the designed installed spacing
• Precision hole pattern aligns mating housings
• Flat plate distributes clamp load across the joint
• Prevents direct wear between adjoining cast components
• Orientation may control access, clearance or sealing features

🔌 Function

Spaces and aligns the adjoining housings or driveline components so shafts, fasteners and mating faces remain correctly positioned.

⚠️ Common Signs of Failure

• Distorted plate creating misalignment
• Fretting around bolt holes
• Incorrect plate omitted during assembly
• Cracks or corrosion at the edge
• Persistent vibration or housing leakage after service

🛠️ Service Notes

• Note which way round the plate came off, and where its dowels, locating pins and any oil or water passages sit; it will often bolt up reversed but will not work
• Clean both faces fully, removing all old gasket and sealant without scoring them, and check the plate for flatness, cracks and corrosion
• Fit new gaskets, seals and O-rings on both sides, and use sealant only where the workshop manual for your engine calls for it
• Draw the fasteners down evenly, in the sequence and to the figures given for your engine, and check for leaks after the first run at temperature

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging