21271982 Sensor | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta electronic pressure sensor used in a specified engine or instrument circuit. The sensor converts system pressure into an electrical signal for the ECU, alarm unit or display and must match the calibrated pressure range and connector coding of the original part.

🚤 Compatibility

• Engine Family: D, TAD, TWD

Full model list at the end of this description.

⚙️ Key Features

• Genuine Volvo Penta pressure sensor
• Electronic signal output for engine monitoring
• Calibrated pressure range and thread specification
• Marine/industrial sealed connector construction
• Match the monitored circuit and engine serial number
• Engine type: Volvo Penta electronically controlled marine or industrial diesel

🔌 Function

Measures the assigned system pressure and transmits a proportional signal for control, display and alarm functions.

⚠️ Common Signs of Failure

• Implausible, fixed or erratic signal values
• Starting, speed-control or protection-system fault codes
• Intermittent signal loss caused by heat or vibration
• Oil, coolant or water contamination in the connector
• Open-circuit, short-circuit or incorrect air-gap test results

🛠️ Service Notes

• Note how the sensor sits and how its lead is routed before removing it, and support the harness so refitting does not leave the cable strained or rubbing
• Turn the sensor with a spanner on its hex only — never lever or twist it by the connector body or the wiring, which breaks the internal joint even when the sensor looks undamaged
• Renew the O-ring or sealing washer where one is fitted, and do not add thread sealant unless the manual for your engine specifies it; sealant on the threads can break the earth path of a sensor that earths through its body
• Tighten to the figure in the workshop manual for your engine — overtightening distorts the housing and shifts or destroys the sensing element
• Make sure the connector is clean, dry and fully latched home and check the pins for corrosion and spread — a poor connector accounts for a great many faults blamed on the sensor — then run the engine and confirm the reading or warning lamp behaves sensibly before returning the boat to service

🔄 Supersession & Cross Reference

Aftermarket / Verified Equivalents

• NRF: 453005

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta D8A2-A MP, D8A5-A MH, D8A6-A MH, D8A5-A MG, D8A6-A MG, D8A4-A MP, D8A1-A MP, D8A3-A MP
• Volvo Penta TAD1640-42GE-B, TAD1640VE-B, TAD1640-42VE-C
• Volvo Penta TAD1641VE-B, TAD1641VE
• Volvo Penta TAD1642VE-B, TAD1642VE
• Volvo Penta TAD1643VE-B, TAD1643VE
• Volvo Penta TAD1650VE
• Volvo Penta TAD1660-62VE
• Volvo Penta TAD1662VE EU5
• Volvo Penta TAD1670-72VE
• Volvo Penta TWD1683VE