21536083 Cover | Genuine Volvo Penta Part

🔧 Product Description

A model-specific protective cover used on a Volvo Penta D16 diesel-engine assembly. The cover closes and shields the component position identified by the applicable D16 parts list for your engine.

⚙️ Key Features

• Genuine Volvo Penta D16 cover
• Approximate weight: 0.255 kg
• Correct factory profile and retaining points
• Designed for D16 engine-room temperature and vibration
• Supplied as an individual replacement component
• Engine type: 16.1 L inline-six turbocharged diesel

🔌 Function

Protects and closes the designated D16 engine component while maintaining the original clearances and mounting arrangement.

⚠️ Common Signs of Failure

• Broken retaining points
• Oil, dirt or moisture reaching the protected component
• Rattling caused by loose fasteners
• Cover no longer seating correctly

🛠️ Service Notes

• Clean both sealing faces back to clean metal and check the cover for distortion, cracks or pulled bolt holes before refitting — a warped flange will not seal even with a new gasket
• Where the joint uses a gasket, seal or O-ring, always fit a new one and seat it dry unless the workshop manual for your engine specifies a sealant; never try to make a poor joint tight with extra sealant
• Tighten the fasteners progressively and evenly, working out from the centre, to the figure given in the manual for your engine — pressed steel, alloy and plastic covers distort easily if pulled down hard or unevenly
• If the cover carries a shaft seal or bearing, support it square to the shaft as it goes on so the seal lip is not nicked or rolled over
• Check that any breather, drain or oil return passage in the cover is clear before final tightening, and look for leaks once the engine has been run up to temperature

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging