21662662 Bilge Pump | Genuine Volvo Penta Part

🔧 Product Description

A genuine Volvo Penta marine bilge pump designed for reliable water removal in the specified manual or electrical installation.

⚙️ Key Features

• Manual diaphragm pump
• Horizontal installation
• Hose connection: 25mm / 1 inch
• Maximum manual output: approximately 90L/min
• Corrosion-resistant marine construction
• Designed for emergency pumping without electrical power

🔌 Function

The pump manually evacuates bilge water through a 25mm hose when electrical pumping is unavailable or as a backup system.

⚠️ Common Signs of Failure

• Reduced pumping capacity
• Diaphragm damage
• Check-valve contamination
• Handle mechanism wear
• Air leakage at hose connections

🛠️ Service Notes

• Mount the pump at the lowest point of the bilge where it will actually pick up, sitting level and secured so it cannot topple or shift at sea, and keep it clear of debris that would jam the impeller
• Take the discharge hose up to a loop above the waterline before it turns down to the outlet so the sea cannot siphon back into the boat, and clamp the hose properly at both ends
• Wire the pump on its own protected circuit with cable sized for the length of the run, and make every connection above the level bilge water can reach, using proper waterproof joints rather than tape
• Test the pump and its float or sensing switch by filling the bilge and watching it lift, run and cut out, and repeat the test at the start of each season
• Treat it as a nuisance-water pump rather than damage control — keep the strainer clear and the bilge dry enough that a new leak would be obvious

🔄 Supersession & Cross Reference

OEM Supersession Chain

• 21662662 → Supersedes 41103015

OEM / Related Numbers

• 41103015 earlier number superseded by this part

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging