22326223 Bracket | Genuine Volvo Penta Part

🔧 Product Description

A genuine formed bracket used to locate and support an engine-mounted component on a Volvo Penta installation. The hole pattern, material thickness and offset are specific to the original assembly, helping the attached component remain aligned under engine vibration and thermal movement.

⚙️ Key Features

• Genuine Volvo Penta mounting bracket
• Original hole spacing, bend geometry and component offset
• Designed for the specified engine-side attachment points
• Reduces vibration and load on attached pipes, wiring or accessories
• Corrosion-protected for engine-room service
• Bracket only; fasteners, bushes and attached component are separate

🔌 Function

Provides a rigid mounting point that maintains the position and alignment of the specified engine component.

⚠️ Common Signs of Failure

• Cracks around bends or mounting holes
• Elongated holes or fretting
• Corrosion, distortion or impact damage
• Loose attached component
• Repeated pipe, hose or wiring damage caused by lost support

🛠️ Service Notes

• Offer the bracket up and start every fastener by hand before tightening any of them, so the component is not pulled into a strained position
• Check the mating faces are clean, flat and free of corrosion scale — a bracket that does not sit flat will work loose and let the component move
• Renew self-locking nuts, lock washers, tab washers or thread-locking compound wherever the original assembly used them, and tighten to the figure given in the workshop manual for your engine
• Where the bracket carries a rubber mount or bush, renew that at the same time rather than reusing a perished one
• On brackets in the inlet and exhaust area, never force alignment to make the holes line up — cure the misalignment at its source, or the bracket and the component it holds will both crack

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging