22371761 Bracket | Genuine Volvo Penta Part

🔧 Product Description

This genuine Volvo Penta evc / ips cable support bracket is used in the following application: Volvo Penta D4 F-generation EVC and IPS electrical installations. Supports the EVC / IPS harness at the correct location so connector loads, vibration and abrasion are controlled. Correct routing protects signal integrity and reduces intermittent electrical faults.

🚤 Compatibility

Typically suits:

• Volvo Penta D4-260D-F
• Volvo Penta D4-300D-F

• Engine Family: D
• HP Range: 260-300 HP

⚙️ Key Features

• Original bracket for securing D4 EVC / IPS cable branches
• Maintains connector strain relief and the specified bend radius
• Keeps harnesses clear of heat sources, belt drive and moving hardware
• Correct hole pattern and stand-off for F-generation D4 installations
• Bracket only; harnesses, cable ties and fasteners are separate
• Inspect the harness insulation and connector locks when replacing the support

🔌 Function

Supports the EVC / IPS harness at the correct location so connector loads, vibration and abrasion are controlled. Correct routing protects signal integrity and reduces intermittent electrical faults.

⚠️ Common Signs of Failure

• Broken or cracked bracket
• Harness sagging into a hot or moving area
• Chafed insulation at the support point
• Loose connector caused by missing strain relief
• Elongated mounting holes or missing cable ties
• Intermittent EVC faults that change when the harness is moved

🛠️ Service Notes

• Offer the bracket up and start every fastener by hand before tightening any of them, so the component is not pulled into a strained position
• Check the mating faces are clean, flat and free of corrosion scale — a bracket that does not sit flat will work loose and let the component move
• Renew self-locking nuts, lock washers, tab washers or thread-locking compound wherever the original assembly used them, and tighten to the figure given in the workshop manual for your engine
• Where the bracket carries a rubber mount or bush, renew that at the same time rather than reusing a perished one
• On brackets in the inlet and exhaust area, never force alignment to make the holes line up — cure the misalignment at its source, or the bracket and the component it holds will both crack

🔄 Supersession & Cross Reference

OEM / Related Numbers

• 22390849 - associated 500 mm EVC / IPS wiring harness
• 22390850 - associated 2500 mm EVC / IPS wiring harness
• 22390852 - associated D4 EVC / IPS wiring harness

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging