22775234 Bracket | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta bracket from the Inlet and Exhaust System group, weighing 0.205 kg and listed for eight D series engine applications.

🚤 Compatibility

Typically suits:

• Volvo Penta D8A2-A MP
• Volvo Penta D8A5-A MH
• Volvo Penta D8A6-A MH
• Volvo Penta D8A5-A MG
• Volvo Penta D8A6-A MG
• Volvo Penta D8A4-A MP
• Volvo Penta D8A1-A MP
• Volvo Penta D8A3-A MP

• Engine Family: D

⚙️ Key Features

• 0.205 kg
• Listed for eight D series engine applications
• Inlet and Exhaust System group

🔌 Function

Supports and locates a component or pipe run in the inlet and exhaust system, taking its weight and holding it steady against vibration.

⚠️ Common Signs of Failure

• Rattle or buzz from the inlet or exhaust side at particular engine speeds
• The supported part hanging out of position
• Cracks starting at a bolt hole or at a bend in the bracket
• Fixings found loose at successive services
• Fretting marks where the bracket rubs what it carries

🛠️ Service Notes

• Offer the bracket up and start every fastener by hand before tightening any of them, so the component is not pulled into a strained position
• Check the mating faces are clean, flat and free of corrosion scale — a bracket that does not sit flat will work loose and let the component move
• Renew self-locking nuts, lock washers, tab washers or thread-locking compound wherever the original assembly used them, and tighten to the figure given in the workshop manual for your engine
• Where the bracket carries a rubber mount or bush, renew that at the same time rather than reusing a perished one
• On brackets in the inlet and exhaust area, never force alignment to make the holes line up — cure the misalignment at its source, or the bracket and the component it holds will both crack

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging