22898650 Propeller Kit | Genuine Volvo Penta Part

🔧 Product Description

A genuine Volvo Penta matched Type G10 Duoprop set for DPH sterndrives. The nickel-bronze-aluminium pair combines a three-blade front propeller and four-blade rear propeller. The two propellers must be installed as a matched G10 pair and must not be mixed with a different G size or Type H propeller.

🚤 Compatibility

Typically suits:

• Volvo Penta D6-300A-G
• Volvo Penta D6-340A-G
• Volvo Penta D6-380A-G
• Volvo Penta DPH-E
• Volvo Penta 527
• Volvo Penta 577S
• Volvo Penta 627SV
• Volvo Penta D6-400A-G
• Volvo Penta D4-150A-G
• Volvo Penta D4-230A-G
• Volvo Penta D4-270A-G
• Volvo Penta D4-300A-G

• Engine Family: D, DPH
• HP Range: 150-400 HP

⚙️ Key Features

• Genuine Volvo Penta Type G10 matched propeller set
• Correct Volvo Penta kit number 22898650
• Three-blade front and four-blade rear NiBrAl construction
• Designed for Volvo Penta DPH high-torque sterndrives
• H10 can replace G10 only when the complete matched front-and-rear set is changed

📋 Kit Contents

• 1 × Type G10 front propeller - 3587404, superseded by 23795440
• 1 × Type G10 rear propeller - 3587405, superseded by 23795450
• Propeller cone, nuts, lock bolt and installation tools are serviced separately

🔌 Function

The contra-rotating pair converts drive torque into thrust, balances steering forces and provides the engine load required to reach the approved wide-open-throttle speed.

⚠️ Common Signs of Failure

• Vibration from bent blades or an unmatched pair
• Corrosion, blade-edge erosion or hub damage
• Front and rear propellers of different sizes or families are mixed

🛠️ Service Notes

• Stop the engine and isolate the start circuit before working at the propeller, and never rely on gear selection alone to hold the shaft
• Clean the shaft and the propeller bore, check the splines or taper for damage, and grease the shaft and hub on assembly so the propeller can be removed again next season
• Fit the parts in the kit in the correct order — thrust washer, propeller, any spacer, then the nut and its locking device — and use the new locking hardware supplied rather than the old pin or tab
• Tighten the propeller nut to the figure given in the workshop manual for your drive and lock it properly; a nut merely nipped up lets the propeller work on the shaft and ruins the splines
• After the first run, recheck the nut and its locking device, and investigate any vibration — that normally means a damaged, out-of-balance or mismatched propeller

🔄 Supersession & Cross Reference

OEM Supersession Chain

• 22898650 → Supersedes 22548200 → Supersedes 3587385 → Supersedes 3863038

OEM / Related Numbers

• 22548200 earlier number superseded by this part
• 3587385 earlier number superseded by this part
• 3863038 earlier number superseded by this part
• 3587404 related reference
• 23795440 related reference
• 3587405 related reference
• 23795450 related reference

Other-Brand OEM Numbers

• VOE22898650

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging