23327137 Wiring Harness | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta wiring harness from the Marine Propulsion group, weighing 0.029 kg and listed for 44 applications across IPS pod drives and D series engines.

🚤 Compatibility

• Engine Family: IPS, D
• HP Range: 145-480 HP

Full model list at the end of this description.

⚙️ Key Features

• Wiring harness from the Marine Propulsion group
• 0.029 kg
• Listed for 44 applications across IPS pod drives and D series engines

🔌 Function

Carries supply and signal wiring over a short run in the drive installation, linking a sensor or actuator into the vessel's control wiring.

⚠️ Common Signs of Failure

• Intermittent fault or warning from the drive that comes and goes with movement
• Connector found green or salty inside
• Insulation chafed where the run crosses a bracket or edge
• Pin pushed back or spread in the connector body
• Continuity lost with the loom flexed by hand

🛠️ Service Notes

• Check the mating connector and its seal before replacing the harness - water ingress usually starts at the joint
• Bed the run back into its original clips so it cannot rub

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging

🔎 Full Model Compatibility

Typically suits:

• Volvo Penta D6-340I-G, D6-380I-G, D6-440I-G, D6-480I-G, D6-300D-G, D6-340D-G, D6-380D-G, D6-440D-G, D6-480D-G, D6-300I-G
• Volvo Penta D8A2-A MP, D8A5-A MH, D8A6-A MH, D8A5-A MG, D8A6-A MG, D8A4-A MP, D8A1-A MP, D8A3-A MP, D8A7-A MP, D8A8-A MP
• Volvo Penta D13C3-B MH, D13C1-B MH, D13C4-B MH, D13C2-B MP, D13C4-B MP, D13C5-B MP, D13C7-B MP, D13C8-B MP, D13C9-A MP
• Volvo Penta D4-175I-G, D4-230I-G, D4-270I-G, D4-320I-G, D4-300I-G, D4-145I-G, D4-175 VG
• Volvo Penta D11C1-A MP, D11C3-A MP, D11C2-A MP, D11C4-A MP
• Volvo Penta IPS10-A, IPS10-B
• Volvo Penta IPS15-C
• Volvo Penta IPS40-A