23607173 Bolt | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta bolt, providing the threaded fastening that clamps components together at their specified torque. Using the original specification preserves the intended clamping load at the joint.

🚤 Compatibility

Typically suits:

• Volvo Penta 557
• Volvo Penta 627
• Volvo Penta 527
• Volvo Penta 577S
• Volvo Penta 627SV

⚙️ Key Features

• OEM Volvo Penta part number 23607173
• 4 used per assembly

🔌 Function

The bolt clamps two or more components together and holds that clamping load in service, its thread and shank sized to carry the joint's tensile and shear loads.

⚠️ Common Signs of Failure

• Loosening or loss of torque at the joint
• Stripped, galled or cross-threaded threads
• Rounded or damaged head preventing correct tooling
• Stretched, necked or sheared bolt after over-torquing
• Corrosion or pitting in the marine environment

🛠️ Service Notes

• Clean and inspect the threads in the casting and on the bolt, and check the bolt is the correct length for the hole it goes into — one that bottoms will not clamp, and one that is too short will strip the thread
• Tighten to the torque figure and sequence given in the workshop manual for your engine; where a stretch or angle-tighten procedure is specified the bolt is single-use and must be renewed
• Lubricate or fit dry exactly as the manual states — the same torque figure applied to an oiled thread puts far more load into the bolt than a dry one
• Fit new washers and locking devices, and use the thread locking or sealing compound specified for that joint
• Discard any bolt that is stretched, necked, corroded in the shank or has damaged threads rather than trying to clean it up and reuse it

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging