6H1-43800-17-8D Aftermarket Yamaha Power Trim/Tilt Assembly for Parsun 50-90HP | Sawley's Select Marine Parts
6H1-43800-17-8D Aftermarket Yamaha Power Trim/Tilt Assembly for Parsun 50-90HP | Sawley's Select Marine Parts
Couldn't load pickup availability
🔧 Product Description
Aftermarket replacement Yamaha 40HP-90HP Two-Wire Trim Motor - Replaces Part Number: 6H1-43880-02
New aftermarket reversible trim motor replacing Yamaha 6H1-43880-02. It is supplied as the motor-only replacement for the matching Yamaha hydraulic power trim unit.
⚙️ Key Features
• Direct replacement for the listed Yamaha motor number
• Two-wire reversible motor
• Three-bolt mounting flange
• Marine corrosion-resistant motor housing
• Motor-to-pump seal renewed during installation
🧰 Kit / Assembly Contents
• 1 × Complete trim/tilt motor - P/N 6H1-43880-02
• 1 × Integrated electrical leads or connector
• 1 × Motor-to-pump seal - supplied according to manufacturer package
🔄 Supersession & Cross Reference
OEM Supersession Chain:
• 6H1-43880-02 (Yamaha OEM motor reference)
OEM / Related Numbers:
• 6H1-43880-00
• 6H1-43880-01
Aftermarket / Verified Equivalents:
• ARCO: 6260
• Sierra: 18-6781
• Recmar: REC6H1-43880-02
🚤 Compatibility
Commonly used on:
• Yamaha outboard electric-hydraulic power trim systems
Typically suits:
• Engine / Drive models:
• 40HP, 50HP, 60HP, 70HP and 90HP two-stroke applications using the later 6H1 unit
• HP / Drive Range: 40HP - 90HP
• System Type: Outboard electric-hydraulic power trim motor
• Year Range: Approximately 1992 onward; model-dependent
• Serial / Component Identification: Confirm wire count, mounting-bolt pattern, drive-shaft length and connector before ordering.
🔌 Function
The reversible 12-volt trim motor drives the hydraulic pump in both directions so the outboard or sterndrive can be raised, lowered and trimmed under load.
Common signs of failure / service requirement:
• Trim or tilt does not operate in either direction
• Motor clicks, turns slowly or draws excessive current
• Intermittent operation caused by worn brushes or corroded wiring
• Pump works only after the motor is struck or cooled
• Water intrusion, corrosion or a burnt electrical smell
📦 Condition
• New aftermarket replacement part
• Brand new
• Supplied in original or equivalent packaging
Share
