884311 Drift | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta drift, a workshop tool weighing 0.064 kg — the lightest of the ten drifts listed here. It carries no engine fitment list of its own, so match it against the tool list for the procedure in the workshop manual.

⚙️ Key Features

• 0.064 kg
• Lightest of the ten drifts listed here
• Workshop tool
• Order by part number against the manual's tool list

🔌 Function

Drives a bearing, bush or seal squarely into or out of its housing without damaging it.

⚠️ Common Signs of Failure

• Striking face burred or mushroomed
• Working end chipped or bruised
• Bent so it no longer drives square
• Corrosion on the guiding surfaces

🛠️ Service Notes

• This is a Volvo Penta service tool for driving bearings, seals, bushes and pins — use it with the correct press or drawing setup so the load goes in square, not off at an angle
• Match the drift to the part being fitted so it bears on the right face; driving a bearing through its rollers or a seal on its lip rather than its outer face will ruin the new part
• Keep the working faces clean, and wipe both the drift and the component before use so grit is not pressed into a bearing seat or sealing surface
• Strike with a soft-faced or engineer's hammer as appropriate, dress off any burr that raises on the struck end, and store the drift so its faces do not get chipped
• Support the housing or shaft properly behind the joint and check that the part has gone fully home to its stop or to the depth given in the workshop manual for your engine

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging