943924 O-Ring | Genuine Volvo Penta Part
943924 O-Ring | Genuine Volvo Penta Part
Couldn't load pickup availability
Available from Volvo Penta international
Typically reaches our store in 10–14 business days
Availability checked daily with Volvo Penta
✓ Authorised Volvo Penta Dealer · Genuine Volvo Penta parts · Ships Australia-wide
🔧 Product Description
Genuine Volvo Penta o-ring, part number 943924, listed in the Gaskets and Seals group. It seals a joint by being compressed into its groove, and is renewed whenever the joint it seals is disturbed. Volvo Penta publishes no fitment, dimensions or assembly detail against this number, so check it against the parts list for your own engine before ordering.
⚙️ Key Features
- Genuine Volvo Penta o-ring
- Gaskets and Seals group
- Renew whenever the joint it seals is opened
- No fitment or dimensions published against this number — check it against the parts list for your engine
🔌 Function
Seals a joint by being compressed into its groove, and is renewed whenever the joint it seals is disturbed.
⚠️ Common Signs of Failure
- A slow weep, drip or wet film at a joint face, union or plug that returns after wiping
- Coolant, oil or fuel loss with no cracked or damaged component to account for it
- Air drawn into a fuel or suction line, giving hard starting, a hunting idle or a rough run
- Seepage that reappears shortly after a joint has simply been re-tightened
- A ring found flattened, twisted, nicked or hardened and squared-off when the joint is opened
🛠️ Service Notes
- Always fit a new O-ring — never refit one that has been removed, as it has already taken a set in its groove
- Clean the groove and both sealing faces and check them for nicks, scoring and corrosion pitting; a damaged groove will leak however good the new seal is
- Smear the ring with a little clean lubricant compatible with the fluid it seals, then roll it into place by hand so it sits untwisted and fully in its groove
- Never lever an O-ring over a sharp edge or thread with a screwdriver; use a blunt plastic tool and protect any edge the ring has to pass
- Assemble the joint squarely and tighten to the figure and sequence given in the workshop manual for your engine — over-tightening extrudes the ring and causes the very leak you were curing
🔄 Supersession & Cross Reference
Aftermarket / Verified Equivalents
- SLP: OR-924
📦 Condition
- Genuine Volvo Penta part
- Brand new
- Supplied in original or equivalent packaging
Shipping & Delivery
Shipping & Delivery
Flat-rate shipping Australia-wide — $14.99 per order, no matter how many parts you add. Orders dispatch from our Kadina, South Australia store. Need it urgently or want to collect in person? Call us on 0412 532 984 before ordering.
Returns & Warranty
Returns & Warranty
14-day change-of-mind returns — if it's not right or you ordered the wrong part, send it back within 14 days in new, unused condition for a refund or exchange. Manufacturer warranties apply to new parts. Full details in our Refunds & Returns policy.
Not sure this fits?
Not sure this fits?
Ask us before you buy — we check part numbers and fitment every day. Call 0412 532 984 (Mon–Fri 8.30am–4.30pm) or message us through the contact page with your engine or vehicle details.
Share
