984293 Shim | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta shim, 0.50 mm thick, listed for 20 applications across DPH, D and DPI drives. It is and the only 0.50 mm shim in the run, so measurement identifies it on its own. The published weights across these shims do not follow thickness, so work from the measured thickness rather than mass.

🚤 Compatibility

Typically suits:

• Volvo Penta DPH-D1
• Volvo Penta D6-330A-F
• Volvo Penta D6-370A-F
• Volvo Penta D4-260A-F
• Volvo Penta D4-300A-F
• Volvo Penta D6-300A-F
• Volvo Penta D4-225A-F
• Volvo Penta D6-300A-G
• Volvo Penta D6-340A-G
• Volvo Penta D6-380A-G
• Volvo Penta DPH-E
• Volvo Penta DPI-A
• Volvo Penta D6-400A-G
• Volvo Penta D6-440A-G
• Volvo Penta D6-400A-F
• Volvo Penta D4-150A-G
• Volvo Penta D4-230A-G
• Volvo Penta D4-270A-G
• Volvo Penta D4-320A-G
• Volvo Penta D4-300A-G

• Engine Family: DPH, D, DPI
• HP Range: 150-440 HP

⚙️ Key Features

• 0.50 mm thick
• Listed for 20 applications across DPH, D and DPI drives
• The only 0.50 mm step in this run
• TH=0.50mm (Volvo assembly listing)

🔌 Function

Sets the endfloat or preload of a bearing or shaft stack by taking up a measured amount of clearance.

⚠️ Common Signs of Failure

• Endfloat or backlash outside specification when the stack is measured
• Whine, growl or rumble from the bearing stack in service
• Shim dished, curled or fretted where it has been clamped
• Bright polished patches or bruising on the shim faces

🛠️ Service Notes

• The other steps in this block are 984290 at 0.10 mm, 984291 at 0.15 mm and 984292 at 0.225 mm
• Measure the shim you removed rather than assuming its thickness, as shims bed in and lose material
• Set the stack up and re-check the reading before final assembly

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging