992392 Terminal | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta terminal, part number 992392. It forms the connection between a conductor and its mating stud, connector or terminal block, and is the point at which most electrical faults on a boat eventually appear. Volvo Penta publishes no fitment, dimensions or assembly detail against this number, so check it against the parts list for your own engine before ordering.

⚙️ Key Features

• Genuine Volvo Penta terminal
• Forms a connection between a conductor and its mating point
• No fitment or dimensions published against this number — check it against the parts list for your engine

🔌 Function

Forms the connection between a conductor and its mating stud, connector or terminal block, and is the point at which most electrical faults on a boat eventually appear.

⚠️ Common Signs of Failure

• Circuit that works intermittently or drops out with vibration, and fault codes or warning lamps that change when the loom or connector is moved by hand
• Discoloured, browned or melted insulation at the terminal, or a terminal that is hot to the touch after running
• Green or white powdery corrosion on the terminal, in the connector shell or wicking back up under the insulation
• Slow cranking, dim instrument lighting or a voltage drop measured across the connection
• Terminal loose in its housing, pushed back out of the connector, slack on its mating pin, or the wire pulling out of the crimp barrel

🛠️ Service Notes

• Use the correct crimp tool and die for the terminal size — a ratcheting crimper is what makes a marine crimp reliable — and pull-test every finished crimp before it goes back in service
• Strip only as much insulation as the barrel will take: no stray strands outside the barrel and no insulation trapped inside it
• Seal the finished crimp against moisture, adhesive-lined heat shrink over the joint being the usual method on a boat
• Crimp rather than rely on solder: solder alone is not an acceptable marine connection, and the stiff spot where the solder ends cracks the strands with vibration
• Clean the mating post or pin to bright metal, tighten to the figure in the manual for your engine, and support the cable so vibration is taken by the clip and not by the terminal

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging