9996012 Drift | Genuine Volvo Penta Part

🔧 Product Description

Genuine Volvo Penta drift, part number 9996012, listed in the Special Tools group. It is a service tool used to drive a bearing, bush, seal or pin squarely into or out of its housing without damaging the component or the bore. Volvo Penta publishes no dimensions or application detail against this number, so confirm it is the right one for the job before ordering.

⚙️ Key Features

• Genuine Volvo Penta drift
• Special Tools group
• Workshop service tool, not a part fitted to the engine
• No dimensions or application detail published against this number

🔌 Function

A service tool used to drive a bearing, bush, seal or pin squarely into or out of its housing without damaging the component or the bore.

⚠️ Common Signs of Failure

• The struck end mushroomed, burred or splitting, which throws off shards in use and no longer takes a square blow
• The driving nose chipped, worn, or no longer a clean fit on the part it is meant to locate
• Bent, scored or corroded shaft, so the tool no longer drives straight and marks the components it is used on

🛠️ Service Notes

• This is a Volvo Penta service tool for driving bearings, seals, bushes and pins — use it with the correct press or drawing setup so the load goes in square, not off at an angle
• Match the drift to the part being fitted so it bears on the right face; driving a bearing through its rollers or a seal on its lip rather than its outer face will ruin the new part
• Keep the working faces clean, and wipe both the drift and the component before use so grit is not pressed into a bearing seat or sealing surface
• Strike with a soft-faced or engineer's hammer as appropriate, dress off any burr that raises on the struck end, and store the drift so its faces do not get chipped
• Support the housing or shaft properly behind the joint and check that the part has gone fully home to its stop or to the depth given in the workshop manual for your engine

📦 Condition

• Genuine Volvo Penta part
• Brand new
• Supplied in original or equivalent packaging